With Manufacturer's Scan Tool

1. Prepare Subaru Select Monitor and cartridge.
(ST1 498307500 Select Monitor Kit)
(ST2 498349601 Cartridge)
2. Turn Ignition Switch and Subaru Select Monitor Switch to "OFF".




3. Insert Cartridge into Subaru Select Monitor.

4. Connect Subaru Select Monitor to Data Link Connector.

^ Using Data Link Connector for Subaru Select Monitor only.

(2) Data link connector (for Subaru select monitor only); (4) Test mode connector:

- Connect Subaru Select Monitor to its data link connector located in the lower portion of the instrument panel (on the driver's side), to the side of the center console box.

^ Using Data Link connector for Subaru Select Monitor and OBD-II General Scan Tool.



a. Connect ST adapter to Subaru Select Monitor Cable.
(ST 498357200 Adapter Cable)





b. Open the cover and connect Subaru Select Monitor to Data Link Connector located in the lower portion of the instrument panel (on the driver's side), to the lower cover.

CAUTION: Do not connect scan tools except for Subaru Select Monitor and OBD-II General Scan Tool.




5. Turn Ignition Switch "ON" (Engine "OFF") and Subaru Select Monitor switch ON.
6. Using Subaru Select Monitor, call up diagnostic trouble code(s) and various data, then record them.


READ DIAGNOSTIC TROUBLE CODE SHOWN ON DISPLAY. (MODE FB1)



1. Press the function key [0].




2. Designate mode using function key. Press [F] [B] [1] [ENT] in that order.

When there is only one diagnostic trouble code:

When there are multiple diagnostic trouble codes:

3. Ensure diagnostic trouble code(s) is shown.

NOTE: For details concerning Diagnostic Trouble Codes (DTC), refer to the Diagnostic Trouble Code Descriptions.