Shift Cable: Service and Repair

REMOVAL

ECVT Transmission Control Cable Removal:

1. Completely drain ATF and remove oil pan.
2. Remove end of cable from pulley; remove bolt.
^ Discard O-ring and replace with new one.
^ To facilitate oil pan removal, remove grille and radiator in advance.

INSTALLATION

ECVT Transmission Control Cable Installation:

1. Install the 0-ring onto the cable, insert the cable into the hole in the transmission case, and tighten with the bolt and washer. Torque to 4.4 - 5.4 Nm (0.45 - 0.55 kg-m, 3.3 - 4.0 ft lb).
2. Route the inner cable along the rib on the transmission case, as shown in the figure. Secure the end of the cable to the hole on the shift control lever and place the cable on the perimeter of the lever.

NOTE: Ensure the inner cable moves smoothly without disturbing the inner wall fo the transmission case and control valve body assembly when pulled from the outside.