Foglight - Installation Information
90subaru03NUMBER 15-81-90
DATE 03-19-90
APPLICABILITY ALL 1990 JUSTY MODELS
SUBJECT: ACCESSORY FOGLIGHT INSTALLATION SUPPLEMENT
Use the information provided in this bulletin to supplement the installation instructions for the genuine Subaru Justy accessory foglight kits SOA385J115 (clear lens) and SOA385J116 (amber lens.)
NOTE: Adaptor Kit SOA385J205 will be needed to install the foglight assemblies to the front bumper.
Tools Required:
^ 1/4" Drive Ratchet, Snap-On P/N TMTOB, TM75OR equivalent
^ 1/4" Drive 411 Extension Bar, Snap-On P/N TMX4 or equivalent
^ 1/4" Drive 10 mm 6 pt. Socket, Snap-On P/N TMME or equivalent
^ 1/4" Drive 12 mm 6 pt. Socket, Snap-On P/N TMM12 or equivalent
^ # 2 Phillips Tip Screwdriver, Snap-On P/N SSDP42, SDDP42 or equivalent
^ Combination Pliers, Snap-On P/N 44P or equivalent
^ Diagonal Cutter Pliers, Snap-On P/N 86ACP or equivalent
Preinstallation:
1. CAUTION: Always disconnect the negative battery terminal whenever an electrical device is being installed or repaired.
FIGURE 1:
Electrical Installation:
2. Remove the underdash panel below the steering column.
3. Locate the white three-pin connector i3 in the harness under the left side of the dashboard. Using the brown tap-in connector supplied in the kit, tap the thick white wire in connector i3 to the white wire (with the in-line fuse holder) from terminal "B" of the foglight relay. (See Figure 1.)
4. Locate the blue four-pin connector i55 in the harness under the left side of the dashboard. Tap into the red wire with the blue tracer using the blue tap-in connector attached to the red wire with a white tracer from the foglight switch. (See Figure 1.)
5. Locate the black six-pin connector i12 in the harness under the steering column. Tap into the red wire with the yellow tracer on 3-door Justy models and red with a black tracer on 5-door Justy models using the blue tap-in connector attached to the red wire with the black tracer from terminal "G" of the foglight relay. (See Figure 1.)
6. Disconnect the foglight rocker switch from the relay harness and carefully remove the left dash plug and push the relay harness connector out of the hole. Plug the rocker switch connectors together and mount the switch into the dash with the dot on the rocker in the upper position.
7. Connect the bullet connector red wire with the black tracer from the switch to the relay.
8. Connect the blue wire from the switch harness to terminal "S" on the relay.
9. Use steps 9 through 24 of the foglight or foglight adaptor kit instructions to complete the installation of the foglight assemblies, the underhood wiring harness routing and proper aiming of the foglight beams.