Caliper Replace

Fig. 2 Exploded view of front caliper assembly. 1985-88 (Typical):

FRONT

1. Remove union bolt and disconnect brake hose from caliper assembly.
2. Remove brake pads as described under ``Brake Pads, Replace.''
3. Remove caliper assembly by pulling from support, Fig. 2.
4. Reverse procedure to install. Torque union bolt to 13 ft.lbs. and, if removed, support bolt to 36-51 ft.lbs. on all except Justy models, or 38-48 ft.lbs. on Justy. Also bleed brakes after installation.

Fig. 4 Exploded view of rear brake caliper assembly:

REAR

1. Raise and support rear of vehicle and remove wheels.
2. Disconnect brake hose from caliper body and plug hose.
3. Remove bolts securing caliper support bracket to trailing arm, then the caliper and support assembly, Fig. 4.
4. Reverse procedure to install, torquing support bolts to 34-43 ft.lbs., then bleed brakes as needed.