AR67.10-P-1600-01MCC Prepare repair for windshield

AR67.10-P-1600-01MCC Prepare Repair For Windshield







1 Tool holder
2 Clamping lever
3 Inspection mirror
4 Milling cutter
5 Stone impact cracker
6 UV curing lamp
7 Bow-shaped blade
8 Filler resin
9 Finish resin
10 Injector
11 Curing foil
12 Cleaning agents
13 Adhesion gel
14 Finish polish

1 Check damaged point for moisture
If applicable, heat damaged point with hot air gun and allow to flash off for approx. 10 minutes.
2 Clean windshield around damaged point with cleaning agent (12).
3 Evaluate damaged point
A conical fissure or filling cavity should be present in each damaged point to ensure that the filler resin (8) continues to flow.
4 If applicable, crack damaged point to create conical fissure or filling cavity.
Use stone impact cracker (5).
5 Install inspection mirror (3) on inside of windshield.
6 Chamfer edges of damaged point using milling cutter (4).
Roughen surfaces and remove grayness from porous surfaces.
7 Blow out loose glass particles and wipe out with paper towel.
Do not use compressed air when blowing out to prevent enlargement of the damaged point.