AN82.10-P-0008-03MCC Retrofit BRABUS Longitudinal Member Panel Lamp Unit

AN82.10-P-0008-03MCC Retrofit BRABUS Longitudinal Member Panel Lamp Unit







Ensure that the wiring harnesses are not damaged by chafing or being trapped otherwise the appropriate wiring harness must be replaced.

Following operation steps are shown on right longitudinal member panel (1). Retrofitting on the left longitudinal member panel is performed in the same manner.

1. Clip lamp units (3) into notches that were previously made on longitudinal member panel (1)
Ensure that lamp units (3) are seated correctly in longitudinal member panel (1).

2. Create electrical connectors (21) with connector of lamp units (3) and wiring harness of longitudinal member panel illumination.
3. Slide electrical connectors (21) into foam brackets (20).
4. Slide coupling (15) through front foam bracket (20).
5. Glue foam bracket (20) to longitudinal member panel (1) as shown with adhesive strips included in delivery contents.
Red side of adhesive strips must point in direction of longitudinal member panel (1).