AZ68.50-P-0005-02MCC Install Anchorings For Divider on Roof Frame

AZ68.50-P-0005-02MCC Install Anchorings For Divider On Roof Frame












450 589 00 28 00, Graduated drill







450 589 01 70 00, Twist drill bit set







1 Fasten adhesive tape (4) to counterplates (2) as shown.
Adhesive tape (4) should not be attached to the contact surface of the counterplates (2) because this would decrease the strength of the bolted connection.
2 Use left or right counterplate (2) to match recess (arrow A) in roof frame.
3 Guide left and right counterplate (2) through opening in roof frame and position above holes (5).
The adhesive tape (4) serves as an installation aid due to the limited clearance when inserting and positioning the counterplates (2).
4 Position anchorings (1) at top on holes (5) and tighten bolts (3) to left and right counterplate (2).
The chamfer (arrow B) on the anchorings (1) should be pointed to the center of the vehicle.







5 Provide for recesses (9) on roof frame paneling (7) according to perforation (arrow D).
The perforation (arrow D) on the roof frame paneling (7) serves as reinforcement and should not be damaged: otherwise, the covers (6) are no longer held properly.
Position graduated bit at corresponding center point and drill hole up to perforation (arrow D).Cut or mill out remaining pieces at side until the recess (9) corresponds to the perforation (arrow D).
Cordless drill/driver, see GOTIS
http://gotis.aftersales.daimlerchrysler.com
6 Drill holes (8) in roof frame paneling (7) according to perforation (arrow E).
The perforation (arrow E) on the roof frame paneling (7) serves as reinforcement and should not be damaged; otherwise the covers (6) are no longer held properly.
7 Position cover (6) on roof frame paneling (7) and turn 90°
The recesses (arrows C) on the covers (6) should point toward rear when installed.