AR26.19-P-0001-05MCU Remove/Install Wiring Harness At Transmission

AR26.19-P-0001-05MCU Remove/Install Wiring Harness At Transmission







1 Disconnect electrical connectors (2, 3) from shift actuator (4).
2 Disconnect electrical connector (5) from park pawl switch (S16/2).
3 Disconnect electrical connector (6) from clutch motor (M18) and electrical connector (7) from transmission rpm sensor.
4 Loosen retaining clips (8) of wiring harness (1) on transmission and expose wiring harness (1).
5 Install in the reverse order.