AR15.18-P-1000-02MCU Disconnect, Connect Engine Wiring Harness At Vehicle Side

AR15.18-P-1000-02MCU Disconnect, Connect Engine Wiring Harness At Vehicle Side







1. Unlock and disconnect electrical connector (2) on ME-SFI [ME] control unit (N3/10)
2. Cut through cable tie (3) on engine wiring harness (1).
Connecting: Replace cable tie (3).

3. Disconnect electrical connector (4) and secondary air injection pump connector (X15).
4. Push grommet (5) for engine wiring harness (1) through the vehicle body opening into the engine compartment.
5. Lift vehicle with lifting platform.
6. Unscrew nuts (6) and remove electrical lines (7) for engine mass.
7. Unclip retaining clip for engine wiring harness (1) on secondary air injection pump holder (M33).
8. Lead engine wiring harness (1) downwards into the engine compartment and to the side between the body and secondary air injection pump (M33).
Attaching: Route engine wiring harness (1) in such a way that it is not damaged by crushing.

9. Connect in reverse order.