AR01.10-P-1000-01MCU Turn Engine to Top Dead Center Position

AR01.10-P-1000-01MCU Turn Engine to Top Dead Center Position







1. Remove expansion clips (1) and remove cover (2)
2. Transfer marking (arrow A) on crankshaft belt pulley (3) to the front side using a suitable colored pencil.
If necessary turn engine at the center bolt (4) of the crankshaft belt pulley (3) in the direction of engine rotation.

3. Rotate engine at crankshaft in direction of engine rotation until marking (arrow A) on crankshaft belt pulley (3) coincides with the TDC marking (arrow B) on the timing case cover (5).
4. Position cover (2) and install expansion clip (1)
If no further turning of engine is required.