AZ82.70-P-0013-04MCD Retrofit iPhone-Kit Cradle

AZ82.70-P-0013-04MCD Retrofit iPhone-Kit Cradle







1. Insert counterholder (12) from behind in the cover of the center console (2) and align with the guides (2.1).
2. Transfer bore holes (arrows) to the cover of the center console (2) and remove counterholder (12)
3. Make bores corresponding to the previously applied markings with a diameter of 4 mm in the cover of the center console (2). Rechargeable drill / screwdriver







4. Carefully enlarge center bore at center console cover (2) (arrow A) until transparent couplings (1.2) of iPhone kit mount wiring harness (1.1) can be guided through.
Only enlarge the bore enough that it can be concealed by the retaining plate (13) later. In the event of contravention the cover of the center console (2) must be replaced.







5. Guide iPhone-kit mount wiring harness (1.1) through the opening in the retaining plate (13).
Observe installation position of retaining plate (13).

6. Guide iPhone-kit mount wiring harness (1.1) through the opening in the center console made previously in the cover of the center console (2).
7. Insert counterholder (12) from behind in the cover of the center console (2) and align.
8. Attach retaining plate (13) from above and fasten with the screws/bolts (14) and nuts (15) contained in the delivery contents together with the counterholder (12) on the center console cover (2).







9. Drill hole (arrow C) with a diameter of 2.5 mm according to the dimensions (a and b) on the right side of the center console cover (2).

Dimensions:
a = 23,5 mm
b = 10,5 mm






10. Clip bracket (16) of the iPhone kit mount (1), as shown, into the retaining plate (13) installed previously
11. Open cover (18) of glove compartment.
On vehicles with code (I63) Glove compartment.

12. Route iPhone kit mount wiring harness (1.1) through right opening (arrow B) between installation opening (17) of smart Entry radio and right instrument panel lower section (19) below instrument panel to previously installed iPhone kit control unit.
The iPhone kit mount wiring harness (1.1) must be routed through the top right opening (arrow B) in the slot of the smart Entry radio, otherwise the iPhone kit mount wiring harness (1.1) may be damaged upon installation of the center console cover (2).

13. Put down cover of center console (2) with iPhone-kit cradle (1) on the center console.
Put down the cover of center console (2) so that it cannot fall down.







14. Connect transparent couplings (1.2) of iPhone kit mount wiring harness (1.1) to iPhone kit control unit (4)
15. Fix wiring harness for iPhone-kit cradle (1.1) with cable ties at suitable points.