AZ82.70-P-0005-11MCU Retrofit Operating Unit For Hands-Free System

AZ82.70-P-0005-11MCU Retrofit Operating Unit For Hands-free System







1 Twist lower section (11.2) of push button for central operation (11) toward left and remove.
2 Insert battery (12) into lower section (11.2) of push button for central operation (11) as shown.
Note polarity of battery (12).
3 Place lower section (11.2) on push button for central operation (11), twist toward right and lock.

Agree on the exact placement of the push button for central operation (11) with the customer before installation.







4 Clean bonding surface of cockpit switch group (S6/1) with suitable cleaning agent (not corrosive toward plastic).
Bonding surface must be dry and free of dust and grease to avoid adhesion problems.
5 Remove carrier foil (11.1) and glue push button for central operation (11) to cockpit switch group (S6/1) as shown.
6 Switch on ignition and at the same time press both control buttons at push button for central operation (11) until green LED at push button for central operation (11) lights up.
The push button for central operation (11) has been taught in.