AZ82.70-P-0005-10MCC Retrofit Additional Instrument of Hands-Free System

AZ82.70-P-0005-10MCC Retrofit Additional Instrument Of Hands-free System

On vehicles without code (V31) Cockpit clock and tachometer package, the display of the hands-free system can be attached to the left or the right of the additional instruments bracket in accordance with the customer request. Installation on vehicles without code (V31) Cockpit clock and tachometer package is shown as an example on the right side.







1 Remove cover (13) from clock (A15p3).
On vehicles with code (V31) Cockpit clock and tachometer package.







2 Remove screws/bolts (16) and remove clock from additional instruments bracket (15).
On vehicles with code (V31) Cockpit clock and tachometer package.
The clock is no longer needed.







3 Saw off unnecessary right or left arm (15.1) of new additional instruments bracket (15) along broken line.
On vehicles without code (V31) Cockpit clock and tachometer package.
The display of the hands-free system can be attached to the left or right of the additional instruments bracket (15) in accordance with the customer request.







4 Install display (A15p5) at additional instruments bracket (15) and tighten with screws/bolts (16).
5 Make a cutout at additional instruments bracket (15) along broken line for leading through electrical wiring harness for display (3).
6 Route electrical wiring harness for display (3) in cutout made as shown.
7.1 Install cover removed from clock at display (A15p5).
On vehicles with code (V31) Cockpit clock and tachometer package.
7.2 Install new cover at display (A15p5).
On vehicles without code (V31) Cockpit clock and tachometer package.












8 Position additional instruments bracket (15) at instrument panel.
9 Route electrical wiring harness for display (3) along broken line.
10 Tighten additional instruments bracket (15) with screws/bolts (17).
11 Form cutouts (18.1 or 18.2) at cover (18) according to perforation (arrow A or arrow B).
On vehicles without code (V31) Cockpit clock and tachometer package.
The cutout is only to be formed on the side on which the display of the hands-free system was installed.