AR62.30-P-1250-01MCF Position Crossmember Below Instrument Panel

AR62.30-P-1250-01MCF Position Crossmember Below Instrument Panel
- 451.3##/4## 1# No markings

















450 589 02 15 00, Drift







452 589 01 23 00, Installation tool







1 Unscrew bolt (2) and remove vertical strut (1).







2 Tighten vertical strut (1) to crossmember (4) with bolts (3).







3 Lay crossmember (4) into vehicle, insert assembly wedge (12) into crossmember (4) and close doors.
The assembly wedge (12) should be in the lowest position
4 Position crossmember (4) in vehicle and secure against falling down with one drift (5) each on left and right.
Aid of helper required
5 Completely unscrew knurled screw (13) and position push-in device (14) as shown.







6 Loosely screw in bolts (6, 7, 8, 9) for crossmember (4).
Aid of helper required Ensure that bolts (6, 7, 8, 9) do not fall into A-pillar opening.







7 Align installation position of crossmember (4) according to specified adjustment dimensions (a to c) in relation to firewall (10) and vehicle floor carrier (11).
Dimension a = outer edge of crossmember (area of lower bearing shell) to firewall, dimension b = outer edge of crossmember (area of rear H-profile) to firewall, dimension c = lower edge of crossmember (area of lower H-profile) to vehicle floor carrier.







8 Align assembly wedge (12) with push-in device (14) by turning knurled screw (13).
Aid of helper required If it is not possible to align the crossmember (4) with inserted drift (5) on left and right, remove both drifts (5) if possible.
9 Remove drift (5) on left and right from crossmember (4).
Aid of helper required.
10 Tighten bolts (6, 7, 8, 9) with specified tightening torque.
Aid of helper required.