Repairs and Inspections Required After A Collision

Repairs and Inspections Required After a Collision

1. INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT

(a) Perform the zero point calibration and sensitivity check if any of the following conditions apply .

* The occupant classification ECU is replaced.

* Accessories (seatback tray and seat cover, etc.) are installed.

* The front passenger seat is removed from the vehicle.

* The passenger airbag ON/OFF indicator (OFF) comes on when the front passenger seat is not occupied.

* The vehicle is brought to the workshop for repair due to an accident or a collision.

NOTICE:
When a vehicle that has been in an accident is brought into the workshop for repair, check the flatness of the floor where the front seat RH is mounted. If the flatness is not within +/-3.0 mm (0.118 in.), adjust it to the specified range.

2. CONDITIONS WHEN INSPECTION OF SRS PARTS IS NECESSARY

(a) When the vehicle is damaged in a collision even when the SRS parts are not deployed.

(b) When an SRS system DTC is output.