FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Scion >> 2013 >> FR-S F4-2.0L (FA20) >> Repair and Diagnosis >> Restraints and Safety Systems >> Seat Belt Systems >> Seat Belt >> Service and Repair >> Removal and Replacement >> Front Seat Outer Belt Assembly >> Removal

Removal






SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: REMOVAL; 2013 MY FR-S [03/2012 -]

1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Service Precautions.

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.

3. REMOVE FRONT DOOR SCUFF PLATE Removal

4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

HINT
Disconnect the front door opening trim weatherstrip to the extent that allows the removal of the luggage compartment trim cover.

5. REMOVE LUGGAGE COMPARTMENT TRIM COVER Removal

6. REMOVE QUARTER TRIM LID SUB-ASSEMBLY Removal

7. REMOVE REAR WINDOW SIDE GARNISH Removal

8. REMOVE REAR QUARTER TRIM FRONT GARNISH Removal

9. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

(a) Turn back the floor anchor cover.









(b) Loosen the bolt and disconnect the floor anchor of the front seat outer belt assembly.

10. REMOVE CENTER PILLAR GARNISH Removal

11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

(a) Loosen the bolt and disconnect the shoulder anchor of the front seat outer belt assembly.





(b) Using a screwdriver with the tip wrapped with protective tape, release the pretensioner connector lock and disconnect the pretensioner connector.









HINT
Tape the screwdriver tip before use.

(c) Remove the 2 bolts and disengage the hook to remove the front seat outer belt assembly.




pro multis Credits:Operation CHARM About Operation CHARM