Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION; 2013 MY FR-S [03/2012 -]

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Engage the 9 guides and install the curtain shield airbag assembly with the 9 bolts in the sequence shown in the illustration.





NOTICE:
* When installing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.
* Do not twist the curtain shield airbag assembly when installing it.

HINT
Install the bolts and guides in order, from the rear.

Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

(d) Connect the curtain shield airbag connector.









NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(e) Push in the lock to install the curtain shield airbag connector.

2. INSTALL ROOF HEADLINING ASSEMBLY

Installation

3. PERFORM DIAGNOSTIC SYSTEM CHECK

Reading and Clearing Diagnostic Trouble Codes

4. INSPECT SRS WARNING LIGHT

Diagnosis System