Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: BRAKE ACTUATOR: REMOVAL; 2013 MY FR-S [03/2012 -]

NOTICE:
Before removing the brake actuator assembly, refer to the "Brake line precaution". Service Precautions

1. REMOVE FRONT WHEEL LH

2. DRAIN BRAKE FLUID

NOTICE:
Wash off the brake fluid immediately if it comes into contact with a painted surface.

3. REMOVE FRONT FENDER LINER LH Removal

4. REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRAKE ACTUATOR BRACKET

(a) Disconnect the harness clamp from the brake actuator bracket.





(b) Disconnect the harness clamp from the brake actuator bracket.





(c) Disconnect the cooler pipe from the clamp.





(d) Disconnect the front speed sensor LH harness clamp from the brake actuator bracket.





(e) Press the wire harness connector locking claw to disengage the locking lever, and turn the locking lever upwards to unlock the connector.









(f) Disconnect the connector from the brake actuator assembly.

(g) Using a union nut wrench 12 mm, disconnect the 2 brake lines from the brake actuator assembly.

NOTICE:
Be careful not to allow the brake fluid to enter the removed connector.





(h) Using a union nut wrench 10 mm, disconnect the 4 brake lines from the brake actuator assembly.

NOTICE:
Be careful not to allow the brake fluid to enter the removed connector.





(i) Remove the brake actuator bracket installation bolt.





(j) Remove the 3 bolts from the brake actuator with bracket.





(k) Remove the brake actuator with bracket from the vehicle body.

NOTICE:
Do not damage the brake tubes.