Disassembly

BRAKE (REAR): REAR BRAKE: DISASSEMBLY; 2013 MY FR-S [03/2012 -]

1. REMOVE REAR DISC BRAKE PISTON

(a) Place a wooden block between the rear disc brake piston and disc brake cylinder.









(b) Slowly apply compressed air to remove the disc brake piston.

CAUTION:
Do not place your fingers in front of the piston when using compressed air.

NOTICE:
Do not spatter brake fluid.

2. REMOVE CYLINDER BOOT

(a) Using a screwdriver with its tip wrapped in protective tape, remove the cylinder boot from the disc brake cylinder.

NOTICE:
Do not damage the inner surface or groove of the cylinder.









3. REMOVE PISTON SEAL

(a) Using a screwdriver with its tip wrapped in protective tape, remove the piston seal.









NOTICE:
Do not damage the inner surface or piston seal groove of the cylinder.

4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

(a) Remove the rear disc brake bleeder plug cap from the rear disc brake bleeder plug.

5. REMOVE REAR DISC BRAKE BLEEDER PLUG

(a) Remove the rear disc brake bleeder plug from the rear disc brake cylinder assembly LH.