Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: INSTALLATION; 2013 MY FR-S [03/2012 -]

HINT
* The procedures listed below are for the LH side.
* Use the same procedures for the RH and LH sides.

1. INSTALL FRONT SPEED SENSOR LH

(a) Install the front speed sensor LH with the bolt.

Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

NOTICE:
Do not allow any foreign matter such as dirt or dust to enter between the steering knuckle and the front disc brake dust cover.

(b) Connect the 6 front speed sensor clamps.

NOTICE:
Securely connect the connector.

2. INSTALL FRONT FENDER LINER LH Removal

3. INSTALL FRONT WHEEL LH

Torque : 120 Nm (1224 kgf-cm, 89 ft-lbf)

4. INSPECT SPEED SENSOR SIGNAL

Test Mode Procedure