Installation
C50 MANUAL TRANSAXLE: DIFFERENTIAL OIL SEAL: INSTALLATION
1. INSTALL TRANSMISSION CASE OIL SEAL
(a) Coat the lip of a new oil seal with MP grease.
(b) Using SST and a hammer, install the new oil seal.
SST : 09710-26011
09710-05061
Drive in depth:
9.4 to 10.4 mm (0.370 to 0.409 in.)
NOTICE:
Do not damage the oil seal lip.
2. INSTALL TRANSAXLE CASE OIL SEAL
(a) Coat the lip of a new oil seal with MP grease.
(b) Using SST and a hammer, install the new oil seal.
SST : 09636-20010
Drive in depth:
1.4 to 2.0 mm (0.0551 to 0.0787 in.)
NOTICE:
Do not damage the oil seal lip.
3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH Installation
4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH Installation
5. INSTALL FRONT AXLE ASSEMBLY LH Installation
6. INSTALL FRONT AXLE ASSEMBLY RH
HINT
The installation procedure for the RH side is the same as that for the LH side.
7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH Installation
8. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT
The installation procedure for the RH side is the same as that for the LH side.
9. INSTALL TIE ROD END SUB-ASSEMBLY LH Installation
10. INSTALL TIE ROD END SUB-ASSEMBLY RH
HINT
The installation procedure for the RH side is the same as that for the LH side.
11. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH Installation
12. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH
HINT
The installation procedure for the RH side is the same as that for the LH side.
13. INSTALL FRONT SPEED SENSOR LH Installation
14. INSTALL FRONT SPEED SENSOR RH
HINT
The installation procedure for the RH side is the same as that for the LH side.
15. INSTALL FRONT AXLE HUB NUT LH Installation
16. INSTALL FRONT AXLE HUB NUT RH
HINT
The installation procedure for the RH side is the same as that for the LH side.
17. INSTALL FRONT WHEELS
18. ADD TRANSAXLE OIL
19. INSPECT AND ADJUST TRANSAXLE OIL Testing and Inspection
20. CHECK VSC SENSOR SIGNAL
Test Mode Procedure
21. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Front Wheel Alignment
22. INSPECT FOR TRANSAXLE OIL LEAK