Installation

SUSPENSION: REAR COIL SPRING: INSTALLATION

1. INSTALL REAR COIL SPRING LH

(a) Install the coil spring insulator lower onto the axle beam.

(b) Install the coil spring insulator upper so that its gap fits onto the end of coil spring.

Text in Illustration

NOTICE:
The paint mark of the coil spring should be towards the underside and rear side of the vehicle.

2. INSTALL REAR COIL SPRING RH

HINT
The installation procedure for the RH side is the same as that for the LH side.

3. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER LH Installation

4. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER RH

HINT
The installation procedure for the RH side is the same as that for the LH side.

5. INSTALL REAR ABSORBER CAP

6. INSTALL REAR ABSORBER CAP

7. INSTALL REAR LH FLEXIBLE HOSE

(a) Connect the flexible hose onto the axle beam with a new clip.

(b) Using a union nut wrench (10 mm), install the brake tube onto the flexible hose while holding the flexible hose with a wrench.

Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
Use the formula to calculate special torque value for situations where the union nut wrench is combined with a torque wrench Service Precautions.

8. INSTALL REAR RH FLEXIBLE HOSE

HINT
The installation procedure for the RH side is the same as that for the LH side.

9. INSTALL SKID CONTROL SENSOR WIRE

(a) Install the skid control sensor wire onto the axle beam with the nut.

Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

(b) Connect the skid control sensor wire connector.

10. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

11. STABILIZE SUSPENSION

(a) Lower the vehicle from the jack.

(b) Bounce the vehicle up and down several times to stabilize the suspension.

12. FULLY TIGHTEN REAR AXLE BEAM Installation

13. FULLY TIGHTEN REAR SHOCK ABSORBER LH Installation

14. FULLY TIGHTEN REAR SHOCK ABSORBER RH

HINT
The installation procedure for the RH side is the same as that for the LH side.

15. FILL RESERVOIR WITH BRAKE FLUID Service and Repair

16. BLEED MASTER CYLINDER Service and Repair

17. BLEED BRAKE LINE Service and Repair

18. BLEED BRAKE ACTUATOR Service and Repair

19. INSPECT FLUID LEVEL IN RESERVOIR Service and Repair

20. INSPECT FOR BRAKE FLUID LEAK

21. INSPECT REAR WHEEL ALIGNMENT

Rear Wheel Alignment

22. CHECK VSC SENSOR SIGNAL

Test Mode Procedure