Installation

BRAKE CONTROL: REAR SPEED SENSOR: INSTALLATION

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (REAR SPEED SENSOR)

(a) Install the rear axle hub and bearing onto the axle beam with the 4 bolts.

Torque : 90 Nm (918 kgf-cm, 66 ft-lbf)

2. INSPECT REAR AXLE HUB BEARING Rear Axle Hub

3. CONNECT SPEED SENSOR WIRE Installation

4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY

5. ADJUST REAR DRUM BRAKE SHOE CLEARANCE Installation

6. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

7. INSPECT REAR WHEEL ALIGNMENT

Rear Wheel Alignment

8. CHECK VSC SENSOR SIGNAL

Test Mode Procedure