Removal

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. REMOVE FRONT WHEEL

2. REMOVE FRONT AXLE HUB NUT Removal

3. SEPARATE FRONT SPEED SENSOR Removal

4. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Removal

5. REMOVE FRONT DISC Removal

6. SEPARATE FRONT LOWER SUSPENSION ARM Removal

7. REMOVE FRONT AXLE ASSEMBLY Removal

8. REMOVE FRONT AXLE HUB HOLE SNAP RING Removal

9. REMOVE FRONT AXLE HUB SUB-ASSEMBLY Removal

10. REMOVE FRONT DISC BRAKE DUST COVER

(a) Remove the dust cover by tapping the back side with a brass bar and hammer.





11. REMOVE STEERING KNUCKLE

(a) Install the removed hub bearing inner race onto the outer side of the hub bearing.





(b) Using SST and a press, remove the hub bearing from the steering knuckle.

SST : 09513-36040

SST : 09950-60010

09951-00650

SST : 09950-70010

09951-07100