Installation

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: INSTALLATION

1. INSTALL STEERING KNUCKLE

(a) Using SST and a press, insert a new hub bearing, with its magnetic rotor side facing the inside of the vehicle, until it reaches the end of the steering knuckle.





SST : 09950-60020

09951-00750

SST : 09950-70010

09951-07100

NOTICE:
* Do not remove the inner race because the hub bearing is built into the oil seal.
* Do not use bearings that have been removed.
* Do not wipe off any grease that has been applied to new bearings.
* Do not bring magnets close to the magnetic rotor surface of the bearing.
* Keep the magnetic rotor surface of the bearing free of foreign matter.

2. INSTALL FRONT DISC BRAKE DUST COVER

(a) Provisionally install a new disc brake dust cover, as shown in the illustration.





Standard Clearance A:

25.5 mm (1.00in.)

(b) Using SST and a hammer, install the disc brake dust cover.





SST : 09223-56010

NOTICE:
* Uniformly press in the disc brake dust cover while sliding SST slightly.
* Surely press in the disc brake dust cover until it comes into contact with the pressing-in base.

(c) Using a chisel, fix the 3 points on the circumference.





NOTICE:
Securely fold each end into the engagement grooves.

3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY Installation

4. INSTALL FRONT AXLE HUB HOLE SNAP RING Installation

5. INSTALL FRONT AXLE ASSEMBLY Installation

6. INSTALL FRONT LOWER SUSPENSION ARM Installation

7. INSPECT FRONT AXLE HUB BEARING LOOSENESS Front Axle Hub

8. INSPECT FRONT AXLE HUB RUNOUT Front Axle Hub

9. INSTALL FRONT DISC Installation

10. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation

11. CONNECT FRONT SPEED SENSOR Installation

12. INSTALL FRONT AXLE SHAFT NUT Installation

13. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

14. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Front Wheel Alignment

15. CHECK FOR SPEED SENSOR SIGNAL

Installation