Installation

LIGHTING (EXT): STOP LIGHT SWITCH: INSTALLATION

1. INSTALL STOP LIGHT SWITCH

(a) Install the stop light switch into the adjuster until it slightly touches the brake pedal.





Text in Illustration





HINT
Do not depress the brake pedal.

(1) Make a quarter turn clockwise to install the stop light switch.





Text in Illustration





HINT
* Do not depress the brake pedal.
* The turning torque for installing the stop light switch is as below.

Torque : 1.5 Nm (15 kgf-cm, 13 in-lbf) or less

(b) Check the stop light switch clearance.

Stop light switch clearance:

0.5 to 2.6 mm (0.020 to 0.102 in.)

(c) Connect the stop light switch connector to the stop light switch.

2. INSTALL LOWER INSTRUMENT PANEL ASSEMBLY Installation

3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

4. INSTALL COWL SIDE TRIM BOARD LH

HINT
Use the same procedure as for the RH side Installation.

5. INSTALL FRONT DOOR SCUFF PLATE LH

HINT
Use the same procedure as for the RH side Installation.