Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND ACCELERATION SENSOR: INSTALLATION

1. INSTALL YAW RATE AND ACCELERATION SENSOR

(a) Connect the connector to the yaw rate and acceleration sensor.

NOTICE:
Make sure that the yaw rate and acceleration sensor connector is connected securely.

(b) Insert the yaw rate and acceleration sensor with the 2 bolts.

Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* Do not damage the yaw rate and acceleration sensor.
* Make sure that the yaw rate and acceleration sensor is installed securely.

2. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

3. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

Programming and Relearning

4. CHECK VSC SENSOR SIGNAL

Test Mode Procedure