Installation

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

HINT
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY

(a) Check the angle of inclination required to lock the retractor.





Text in Illustration





(1) Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.

NOTICE:
Do not disassemble the retractor.

If the operation is not as specified, replace the front seat outer belt.

(b) Hook the lower stay of the retractor onto the 2 body hooks and provisionally install the retractor with the 2 bolts.





(c) Tighten bolt A and then bolt B.

for Bolt A - Torque : 4.8 Nm (49 kgf-cm, 42 in-lbf)

for Bolt B - Torque : 41 Nm (420 kgf-cm, 30 ft-lbf)

(d) Connect the pretensioner connector.





Text in Illustration





(1) Connect the pretensioner connector.

(2) Lock the locking button.

NOTICE:
Securely lock the locking button.

(e) Install the shoulder anchor with the bolt.





Torque : 41 Nm (420 kgf-cm, 30 ft-lbf)

(f) Install the floor anchor with the bolt.





Torque : 41 Nm (420 kgf-cm, 30 ft-lbf)

(g) Check that the ELR locks.

NOTICE:
* The check should be performed with the front seat outer belt installed.
* Do not allow the anchor part of the front seat outer belt and the protruding parts of the floor panel to overlap.

(1) With the belt installed, check that the belt locks when it is pulled out quickly.

If the operation is not as specified, replace the front seat outer belt.

(h) Remove the bolt and the anchor plate.

2. INSTALL CENTER PILLAR UPPER GARNISH Installation

3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY Installation

4. INSTALL SIDE NO. 1 TRIM ASSEMBLY Installation

5. INSTALL DECK TRIM SIDE BELT HOLE COVER Installation

6. INSTALL BACK DOOR WEATHERSTRIP

(a) Install the back door weatherstrip.

7. INSTALL REAR DECK TRIM COVER Installation

8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

(a) Install the front door opening trim weatherstrip.

9. INSTALL FRONT DOOR SCUFF PLATE Installation

10. INSTALL REAR SEAT ASSEMBLY

Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

12. INSPECT SRS WARNING LIGHT

Diagnosis System