Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: KNEE AIRBAG ASSEMBLY (for Driver Side): INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

1. INSTALL KNEE AIRBAG ASSEMBLY

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Engage the 2 guides and install the knee airbag assembly with the 3 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(d) Connect the airbag connector.





Text in Illustration





(e) Push in the locking button.

NOTICE:
Securely lock the locking button.

2. INSTALL LOWER INSTRUMENT PANEL ASSEMBLY Installation

3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

4. INSTALL COWL SIDE TRIM BOARD LH

HINT
Use the same procedure as for the RH side Installation.

5. INSTALL FRONT DOOR SCUFF PLATE LH

HINT
Use the same procedure as for the RH side Installation.

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

7. INSPECT SRS WARNING LIGHT

Diagnosis System