Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
* Check that the negative battery terminal is disconnected before performing the operation. Even an impact to only the center airbag sensor assembly will cause the airbag to deploy.
* Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Install the center airbag sensor assembly with the 3 bolts.

Torque : 17.5 Nm (178 kgf-cm, 13 ft-lbf)

NOTICE:
* Do not use a center airbag sensor assembly that has been dropped.
* Do not subject the center airbag sensor assembly to any impact or force.
* Check that the carpet does not interfere with the installation plane.

(d) Check that there is no looseness by shaking the center airbag sensor assembly.

(e) Connect the connector holder to lock the lever.





Text in Illustration





NOTICE:
Check that the lever is locked.

(f) Check that the drip-proof sheet has not been removed and does not cut into the connectors.





Text in Illustration





2. INSTALL SHIFT LEVER ASSEMBLY

Installation

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

4. INSPECT SRS WARNING LIGHT

Diagnosis System