Installation

POWER DISTRIBUTION: MAIN BODY ECU: INSTALLATION

1. INSTALL MAIN BODY ECU

NOTICE:
Make sure that there is no foreign matter in the engaging part.

(a) Contact the main body ECU guide against the housing side wall.

Text in illustration

HINT
The angle between the junction block and the main body ECU guide should be 20° or more.

(b) While aligning the guide with the housing side wall, slide the main body ECU toward the fuse area of the junction block.

Text in illustration

NOTICE:
Slide the ECU gently. Do not apply strong impact to the side of the main body ECU.

(d) Rotate the main body ECU while holding it against the junction block A surface (axis of rotation).

Text in illustration

(e) Rotate the main body ECU until it engages with the lock to install it.

Text in illustration

NOTICE:
* When pressing the main body ECU, press the shaded section shown in the illustration.
* A lock sound will be heard when the main body ECU is engaged.

HINT
If a lock sound is not heard, visually check the lock engagement. Check that the height of the main body ECU and junction block match.

2. INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

(a) Install the bracket with the nut.

(b) Connect the connectors on the back side.

(c) Install the instrument panel junction block with the 2 nuts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(d) Connect the connectors on the front side.

3. INSTALL LOWER INSTRUMENT PANEL ASSEMBLY Installation

4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT
Use the same procedure as for the RH side Installation.

5. INSTALL COWL SIDE TRIM BOARD LH

HINT
Use the same procedure as for the RH side Installation.

6. INSTALL FRONT DOOR SCUFF PLATE LH

HINT
Use the same procedure as for the RH side Installation.