Replacement

AXLE AND DIFFERENTIAL: REAR AXLE HUB BOLT: REPLACEMENT

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. REMOVE REAR WHEEL

2. REMOVE REAR BRAKE DRUM Removal

3. REMOVE REAR AXLE HUB BOLT

(a) Using SST and a screwdriver or the equivalent, remove the hub bolt.





SST : 09610-20012

4. INSTALL REAR AXLE HUB BOLT

(a) Install a washer and nut to a new rear axle hub bolt as shown in the illustration.





Text in Illustration





Recommended service nut:

Thread diameter
12.0 mm (0.472 in.)

Thread pitch
1.5 mm (0.0591 in.)

HINT
Recommended thickness of the washer is 5 mm (0.197 in.) or more.

(b) Using a screwdriver or the equivalent to hold the hub and bearing, install the hub bolt by tightening the nut.

5. INSTALL REAR BRAKE DRUM

6. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)