Replacement

AXLE AND DIFFERENTIAL: FRONT AXLE HUB BOLT: REPLACEMENT

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. REMOVE FRONT WHEEL

2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Removal

3. REMOVE FRONT DISC Removal

4. REMOVE FRONT AXLE HUB BOLT

(a) Temporarily install the 2 nuts and washers to the front axle hub bolt as shown in the illustration.





Text in Illustration





Recommended service nut:

Thread diameter
12.0 mm (0.472 in.)

Thread pitch
1.5 mm (0.0591 in.)

(b) Using SST and a screwdriver or the equivalent to hold the front axle, remove the front axle hub bolt.

SST : 09628-10011

5. INSTALL FRONT AXLE HUB BOLT

(a) Install a washer and nut to a new front axle hub bolt as shown in the illustration.





Text in Illustration





Recommended service nut:

Thread diameter
12.0 mm (0.472 in.)

Thread pitch
1.5 mm (0.0591 in.)

HINT
Recommended thickness of the washer is 5 mm (0.197 in.) or more.

(b) Using a screwdriver or the equivalent to hold the hub and bearing, install the hub bolt by tightening the nut.

6. INSTALL FRONT DISC Installation

7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation

8. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)