Installation

LIGHTING (EXT): REAR COMBINATION LIGHT ASSEMBLY: INSTALLATION

1. INSTALL BACK UP LIGHT BULB

(a) Install the back up light bulb into the light socket.





(b) Turn the back up light socket and bulb, in the direction indicated by the arrow in the illustration, to install them.

2. INSTALL REAR TURN SIGNAL LIGHT BULB

(a) Install the rear turn signal light bulb into the light socket.





(b) Turn the rear turn signal light socket and bulb, in the direction indicated by the arrow in the illustration, to install them.

3. INSTALL TAIL AND STOP LIGHT BULB

(a) Install the tail and stop light bulb into the light socket.





(b) Turn the tail and stop light socket and bulb, in the direction indicated by the arrow in the illustration, to install them.

4. INSTALL REAR COMBINATION LIGHT LENS GASKET

(a) Install a new rear combination light lens gasket.

5. INSTALL REAR COMBINATION LIGHT ASSEMBLY

(a) Engage the guide and install the rear combination light onto the vehicle.

(b) Install the bumper retainer with the screw.

(c) Install the 3 nuts.

Torque : 3.2 Nm (32 kgf-cm, 28 in-lbf)

(d) Connect the 3 connectors.

6. INSTALL REAR BUMPER SIDE SEAL Installation

7. INSTALL SIDE NO. 1 TRIM ASSEMBLY

HINT
Use the same procedure as for the RH side Installation.

8. INSTALL DECK TRIM SIDE BELT HOLE COVER

HINT
Use the same procedure as for the RH side Installation.

9. INSTALL REAR DECK TRIM COVER Installation

10. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

11. INSTALL FRONT DOOR SCUFF PLATE

HINT
Use the same procedure as for the RH side Installation.