Installation

METER / GAUGE / DISPLAY: COMBINATION METER: INSTALLATION

1. INSTALL COMBINATION METER ASSEMBLY

(a) Connect the 2 connectors.

(b) Engage the 2 clips.

(c) Install the combination meter with 2 screws.

2. INSTALL INSTRUMENT CLUSTER FINISH NO. 1 PANEL Installation

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

NOTICE:
When the power to the combination meter is disconnected and reconnected, it will not function normally until 5 minutes elapse or a vehicle speed signal is input.