Installation

BRAKE (FRONT): FRONT BRAKE FLEXIBLE HOSE: INSTALLATION

NOTICE:
* Because the rear flexible hose LH and RH are not interchangeable, verify the part number when installing the rear flexible hoses.
* If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure listed is for the LH side.

1. INSTALL FRONT FLEXIBLE HOSE

(a) Connect the front flexible hose to the disc brake cylinder assembly with a new union bolt and a new gasket.

Torque : 30 Nm (301 kgf-cm, 22 ft-lbf)

(b) Install the front flexible hose to the absorber bracket with the 2 bolts.

Torque : 29 Nm (300 kgf-cm, 22 ft-lbf)

HINT
Install the front speed sensor first and then the front flexible hose.

(c) Install a new clip to the front flexible hose.

NOTICE:
Install the clip as far as it will go.

(d) Using a union nut wrench 10 mm, connect the brake tube to the front flexible hose while holding the flexible hose with a wrench.

Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
* Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Service Precautions.
* Do not kink or damage the brake line.
* Do not allow any foreign matter such as dirt or dust to enter the brake line from the clip or bracket.

2. BLEED BRAKE LINE

Service and Repair

3. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)