Disassembly

BRAKE (REAR): REAR BRAKE: DISASSEMBLY

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure listed is for the LH side.
* The rear wheel brake cylinder assemblies can be disassembled and inspected with the rear wheel brake cylinder assemblies installed to the backing plate. It is not necessary to remove the rear wheel brake cylinder assemblies from the backing plates except when the rear wheel brake cylinder assemblies should be replaced.

1. REMOVE REAR BRAKE SHOE KIT

(a) Using SST, separate the shoe return spring from the rear brake shoe.





SST : 09921-00010

NOTICE:
Do not damage the wheel cylinder boot.

(b) Remove the tension spring.





SST : 09921-00010

(c) Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.





SST : 09718-00011

(d) Remove the shoe return spring from the rear brake shoe and remove the rear brake shoe strut set.





(e) Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.





SST : 09718-00011

(f) Using needle-nose pliers, separate the parking brake cable.





2. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER

(a) Remove the rear brake automatic adjust lever tension spring and rear brake automatic adjust lever.





3. REMOVE REAR DRUM BRAKE BLEEDER PLUG CAP

4. REMOVE REAR DRUM BRAKE BLEEDER PLUG

5. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY

(a) Using a union nut wrench (10 mm), disconnect the brake tube from the rear brake wheel cylinder assembly.





(b) Remove the bolt and rear wheel brake cylinder assembly from the backing plate.





6. REMOVE REAR WHEEL CYLINDER CUP KIT

(a) Remove the 2 wheel cylinder boots from the rear wheel brake cylinder assembly.





(b) Remove the 2 pistons.

(c) Remove the rear wheel brake cylinder compression spring from the rear brake wheel cylinder assembly.

(d) Remove the wheel cylinder cup from each piston.