Slip Indicator Light Does Not Come on

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: Slip Indicator Light does not Come ON
- Slip Indicator Light does not Come ON

DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON Slip Indicator Light Remains on.

INSPECTION PROCEDURE

NOTICE:
* When replacing the brake actuator assembly, perform zero point calibration and store system information Programming and Relearning.
* Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. CHECK CAN COMMUNICATION SYSTEM Slip Indicator Light Remains on

B -- CHECK CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.

2. PERFORM ACTIVE TEST USING TECHSTREAM (SLIP INDICATOR LIGHT) Slip Indicator Light Remains on

NG -- GO TO METER / GAUGE SYSTEM Meter / Gauge System

OK -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal