Initialization not Completed - Tire Pressure Monitoring

TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: C2177/77: Initialization not Completed
C2177/77 - Initialization not Completed

DESCRIPTION

Initialization is necessary if one of the following occurs: 1) the ECU is replaced; 2) the tire pressure warning valve and transmitter is replaced; 3) tires with a different tire standard pressure are installed; 4) the tires are rotated; or 5) a new vehicle is delivered.





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using a Techstream and write them down before removal.
* It is necessary to perform initialization Initialization after registration Registration of the transmitter IDs into the tire pressure warning ECU after the ECU and/or valve and transmitter has been replaced.

PROCEDURE

1. CHECK FREQUENCY RECEIVING CONDITION

(a) Check if the vehicle is located in areas such as the ones described below:

(1) Facilities or devices that use similar radio frequencies are located in the vicinity of the vehicle.

HINT
If the vehicle is located in areas described above, the tire pressure warning light may turn on only in a particular area.

(2) Devices using similar radio frequencies are used in the vehicle.

OK:

Facilities, or devices that use similar radio frequencies are not located in the vicinity of the vehicle.

HINT
Radio frequency may be interrupted due to surroundings or devices installed by the user.

NG -- CHECK IF ANY DEVICE IS INSTALLED BY USER
OK -- Continue to next step.

2. PERFORM INITIALIZATION

(a) Perform initialization Initialization.

NEXT -- Continue to next step.

3. CONFIRM TIRE INFLATION PRESSURE (DATA LIST)

(a) Turn the ignition switch off.

(b) Connect a Techstream to the DLC3.

(c) Turn the ignition switch to ON and turn the tester on.

(d) Enter the following menus: Chassis / Tire Pressure Monitor / Data List /

(e) Check the values by referring to the table below.

Tire Pressure Monitor





HINT
* *: It may take about 2 or 3 minutes until the values are displayed.
* When no "ID Tire Inflation Pressure" data has changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270°. Then rapidly release the tire pressure and recheck it.

Result





B -- END

A -- GO TO DTC C2121/21 TO C2124/24 C2121