Installation

CLUTCH: CLUTCH PEDAL SWITCH: INSTALLATION

1. INSTALL CLUTCH PEDAL SWITCH ASSEMBLY (for Cruise Control System) Installation

2. INSTALL CLUTCH PEDAL SWITCH ASSEMBLY (for Clutch Start System)

(a) Install the clutch start switch with the nut.

Torque : 16 Nm (160 kgf-cm, 12 ft-lbf)

(b) With the clutch pedal depressed to the fully depressed position, check that the clearance shown in the illustration is 1.7 to 4.7 mm (0.0670 to 0.185 in.).





3. INSPECT CLUTCH PEDAL SWITCH ASSEMBLY (for Clutch Start System)

Clutch System

4. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Installation