Installation

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL STEERING KNUCKLE LH

(a) Secure the steering knuckle in a vise.

NOTICE:
When using a vise, do not overtighten it.

(b) Install the front brake dust cover to the steering knuckle.

(c) Install the front axle hub sub-assembly with the 4 bolts.

Torque : 96 Nm (979 kgf-cm, 71 ft-lbf)

NOTICE:
Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.

2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH Installation

3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

Installation