Removal

REAR SUSPENSION: REAR UPPER ARM: REMOVAL

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. REMOVE REAR WHEEL

2. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH





(a) Using a jack and wooden block, raise the vehicle and hold the rear No. 2 suspension arm assembly LH with the rear axle carrier at the standard vehicle height.

(b) Remove the 2 bolts, 2 nuts and upper control arm.





NOTICE:
Since a stopper nut is used, remove the bolt.