Rear Lower Arm

REAR SUSPENSION: REAR LOWER ARM: INSPECTION

1. INSPECT REAR NO. 1 SUSPENSION ARM ASSEMBLY LH





(a) Inspect the turning torque of the ball joint.

(1) Install the installation nut to the ball joint stud.

(2) Move the stud back and forth 5 times. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

Standard turning torque:

0.5 to 3.4 N*m (5.1 to 36 kgf*cm, 4.4 to 30 in.*lbf)

If the turning torque is not within the specified range, replace the rear No. 1 suspension arm with a new one.

(b) Check the dust boots for cracks or grease leakage.