Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: REMOVAL

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Removal

2. REMOVE REAR WHEEL

3. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH Removal

4. REMOVE REAR DISC Removal

5. REMOVE SKID CONTROL SENSOR WIRE LH

(a) Disconnect the skid control sensor wire connector from the vehicle side connector on the rear floor.

(b) Disconnect the grommet of the skid control sensor wire from the hole of the wheel house.





(c) Remove the bolt and sensor clamp from the wheel house gusset.





(d) Remove the bolt and sensor clamp from the trailing arm bracket.





(e) Detach the sensor clamp.





(f) Disconnect the connector.

6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH

Removal

HINT
* The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
* If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.