Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: REMOVAL

HINT
* Use the same procedure for the RH and LH sides.
* The following procedure is for the LH side.

1. REMOVE FRONT WHEEL

2. REMOVE FRONT FENDER LINER LH

HINT
It is not necessary to fully remove the fender liner. Partially remove it so that the speed sensor connector can be disconnected in a later step.

3. REMOVE FRONT SPEED SENSOR LH

(a) Remove the 2 front speed sensor wire harness clamps and disconnect the front speed sensor connector.

(b) Remove the bolt and No. 2 sensor clamp from the body.

Text in Illustration

(d) Remove the clamp from the front shock absorber assembly.

(e) Remove the bolt and front speed sensor from the steering knuckle.

NOTICE:
* Prevent foreign matter from adhering to the front speed sensor tip.
* Clean the front speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.