Installation

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: INSTALLATION

1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Installation

NOTICE:
* Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
* Do not rotate the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
* Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
* Do not remove the steering angle sensor from the spiral cable with sensor sub-assembly.

2. INSTALL STEERING COLUMN COVER Installation

3. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

4. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY Installation

5. INSTALL STEERING WHEEL ASSEMBLY

Installation