Installation

2AR-FE ENGINE CONTROL: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:
Make sure that the O-ring is not cracked or jammed when installing the sensor.

(b) Clean the bolt and bolt hole.

(c) Apply adhesive to 2 or 3 threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.

(d) Install the sensor with the bolt.

Torque : 6.5 Nm (66 kgf-cm, 58 in-lbf)

(e) Connect the sensor connector.

2. INSPECT FOR OIL LEAK Replacement

3. INSTALL REAR ENGINE UNDER COVER RH Installation