Installation

BRAKE (FRONT): FRONT BRAKE FLEXIBLE HOSE: INSTALLATION

HINT
* Use the same procedure for the RH and LH sides.
* The following procedure is for the LH side.

NOTICE:
* Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.
* If the hoses are to be reused, connect them after checking the identification marks placed when each hose was removed.

1. INSTALL FRONT FLEXIBLE HOSE

(a) Install a new gasket and connect the front flexible hose to the disc brake cylinder assembly with a new union bolt.

Torque : 29 Nm (296 kgf-cm, 21 ft-lbf)

(b) Install a new clip to the front flexible hose.

NOTICE:
Make sure the clip is completely pushed in.

(c) Using a union nut wrench, connect the brake line to the front flexible hose while holding the flexible hose with a wrench.

Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
* Do not kink or damage the brake line.
* Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
* Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Service Precautions.

(d) Install the front flexible hose and speed sensor harness bracket to the absorber bracket and steering knuckle with the 2 bolts.

Torque : 19 Nm (192 kgf-cm, 14 ft-lbf)

HINT
Install the front flexible hose first, and then the speed sensor harness bracket.

(e) Attach the speed sensor harness clamp to the absorber bracket.

2. BLEED BRAKE LINE Service and Repair

3. BLEED CLUTCH LINE (for Manual Transaxle) Procedures

4. INSTALL CENTER COWL TOP VENTILATOR LOUVER Service and Repair

5. INSPECT FOR BRAKE FLUID LEAK

6. INSTALL FRONT WHEEL Installation