Installation

DOOR LOCK: BACK DOOR LOCK: INSTALLATION

1. INSTALL BACK DOOR LOCK ASSEMBLY

NOTICE:
* When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.
* When installing a new back door lock assembly, if there are any strings attached to it, cut the strings off.

(a) Temporarily install the back door lock assembly by temporarily installing the 3 bolts in alphabetical order.





(b) Tighten the 3 bolts in alphabetical order.

Torque : 8.0 Nm (82 kgf-cm, 70 in-lbf)

(c) Attach the clamp.

(d) Connect the connector.

2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY Reassembly

3. INSTALL BACK DOOR SIDE GARNISH LH Reassembly

4. INSTALL BACK DOOR SIDE GARNISH RH Reassembly

5. INSTALL BACK DOOR CENTER GARNISH Reassembly