Removal

C50 MANUAL TRANSAXLE: DIFFERENTIAL OIL SEAL: REMOVAL

1. DRAIN TRANSAXLE OIL

(a) Remove the filler plug and the gasket.

(b) Remove the drain plug and gasket, and then drain the manual transaxle oil.

(c) Install a new gasket and the drain plug.

Torque : 39 Nm (400 kgf-cm, 29 ft-lbf)

2. REMOVE FRONT WHEELS

3. REMOVE FRONT AXLE HUB NUT LH Removal

4. REMOVE FRONT AXLE HUB NUT RH

HINT
The removal procedure for the RH side is the same as that for the LH side.

5. SEPARATE FRONT SPEED SENSOR LH Removal

6. SEPARATE FRONT SPEED SENSOR RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

7. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH Removal

8. SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

9. SEPARATE TIE ROD END SUB-ASSEMBLY LH Removal

10. SEPARATE TIE ROD END SUB-ASSEMBLY RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

11. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH Removal

12. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

13. SEPARATE FRONT AXLE ASSEMBLY LH Removal

14. SEPARATE FRONT AXLE ASSEMBLY RH

HINT
The separation procedure for the RH side is the same as that for the LH side.

15. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal

16. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH Removal

17. REMOVE TRANSAXLE CASE OIL SEAL





(a) Using SST, remove the oil seal.

SST : 09308-00010

18. REMOVE TRANSMISSION CASE OIL SEAL





(a) Using SST, remove the oil seal.

SST : 09308-00010